Search results

I have a set of Dakota Digitals in my 79 squarebody that I LS swapped. They are SO nice. I doubt I put a set in my cucv due to the cost of them but they are absolutely worth it.

Thanks for posting that. I have discovered that diagram in my searches. I am trying to figure out what style terminals they used so I can track some down (ie. Packard 56, 59, etc)

Hey guys, Long time lurker, first time poster. I have searched multiple threads and online sources but I cannot find a clear answer. Someone has previously cut some wires from my stock glow plug controller card. I am looking to rewire the truck back to stock but some of the wires have been...

I realize this is an old post but I stumbled across it while searching for some info on my M1008. I have just replaced this rear temp sender in my truck with the SU102 from Autozone (I found the part number here on SS). Once I got the sender, I realized its a late model sender for a LS engine...

LB, I ran across your thread where you had threaded inserts made for your starter bolt holes. How are they holding up for you? I am running into a similar situation with my M1008. Did you happen to have any extra threaded inserts made? If not, who did you have to make them? I see you're in...

I'm a bit late to the game but if you haven't already, I suggest checking out Scotty's LS swap mounts for square trucks. They keep the oil pan from hanging too low and they also retain ability to use the LS truck compressor if you want to add AC. Also, you will want to upgrade your driveshaft...