Search results

Anyone know where in the manual it gives the procedure for determining how many shims to use in the input seal retainer? Closest I saw was how to install a new seal in the old retainer. I ended up with a new retainer as well and I'm not 100% sure the same spacing will work. Or will it still be...

Anyone got advice on removing the front upper ball joints? I've got one stuck and my air hammer just scarred things up (it's a harbor freight joke though, I'm planning on borrowing a decent one). Thanks.

Does anyone know a good replacement for the dash bulbs? I got a pair of Sylvania 1891 bulbs that fit and turned on, but apparently they were too much for the housings and melted them to the point I had to chip them out. All I found in a search was the LED replacements. Thanks.

I'll first say that I now have a vehicle I've wanted for 20 years because of Govplanet, and I appreciate that. I'm sure it's no small task to work between the gov't and the everyday joe. In the big picture I'm happy they're around and appreciate what they're doing. However, I'm curious if...

I put in my new PCB but still have no wait light. I've been searching a bit and that's the story I keep coming up with. I was also going to do the glow plugs and see what happens, but two of the three I got on were stuck so I have to fight those now. Planning on revisiting that tomorrow eve and...

Looks like other people are doing introductions, figured I'd do the same. Name's Justin but I prefer Kaz. Got the new M998 HMMWV in last night and I'm getting a grip on the little repairs it needs. Nothing too bad so far, though if that PCB is bad it'll be a bit pricey, just a couple other minor...