Search results

Not sure about distributor but purchased from green mountain generators.

Yes, that is how my starter is hooked up. I took it off and tested it and it is bad.

I connected the wire with the yellow sleeve to the 24 volt input and nothing happened. Brand new starter but thinking it is bad.

How do I test my starter for proper function? How do I jump it? I replaced it but don’t hear anything engaging.

I finally had a chance to quickly test the K2. The X1 had no VDC when I engaged the S1 but did have 5 volts when I engaged the S10. When the S10 was engaged, the K2 would click loudly at first and then I would hear smaller quick clicking.

I have finally seen the light....let me test and I will let you know. Thanks.

Found the K2 wiring diagram in the manuals but not quite sure what I am looking at. X1 and X2 are the larger wires (I think) and A1 and A2 are the smaller ones. On my unit, on of the larger lugs has three wires and the other lug just one wire. I have attached a picture. Thanks for the feedback.

Thanks for the reply. which wire is the X1 and is there a diagram where I can find this information?

Have a 1993 MEP-802a that ran fine until last week it wouldn't start. I have read a lot of posts on here about this problem but none helped me. The motor won't turn over from Master Switch or Dean Crank Switch. When I try to start with master switch, dead crank, or jumping the starter all I...

Great information guys. Thank you. I have a guy interested in my 804a but will need to decide whether to convert my 004a or part with both and get a 803a. I love my 004a but it is big and noisy.

Great. Thank you for the information. Is there a "down side" to doing it this way? What about balancing the load? I also thought about runing some 120v outlets from the third leg to use externally. Possible?

Let me start by saying I am new to this forum and am amazed by the knowledge of many on here. I recently purchased both a 004a and 804a and working/learning the machines has become an obsession. That being said, I have read many threads and understand converting the 004a to single phase...