Search results

Also, if you are planning on any trailer over 10001, you will need a class a cdl.

Dont' miss the big picture here in pa, if your trailer is rated at 10000 gvw or lower you don't need a cdl, at 10001 you do.

as offered by others, ilkike the ord stuff on my truck (m1028). i added both the drop pitman arm and a riser on the knuckle (6" lift). i lowered my t case with the factory spacers, and i have the stock rear d.s. you should not have any issue with the front d. s. at all. mark youre rear shaft...

lift kit dilema wow! lots of ideas, however i too much opinion is probably confusing the point. 1st lowering the t case will make the front drive shaft axle worse, and the rear drive shaft angle better. 2nd u joints were designed to run on two inputs or outputs on the same axis at different...

Did you consider a rear mount? lots of room back there, especially if no underbed mounted spare tire. Recovery of yourself usually means going backwards, and you can always use a snatch block to run the cable to the front is desired. recovery of others from the back of the truck adds some...

depending on the grade of stainless, a magnet can stick. most never chrome stainless simply becuase stainless can be polished to a luster equal to chrome. yes you should gring off the plating especially if the metal is thin or if you have a low amp mig.2cents

anybody have good p-work for an m35a2? i bought one for myself with good papers, and i just bought another for my dad, no paper. i want to get it on the road and the broadway title thing seems like too much hassle. any help?

just installed my new air assist kit today. it was a pretty straight forward install. i found the bushings at the air cylinder a bit of a challenge. im very pleased with the uprgade. i was actually able to to make left and right turns with one hand. for those just thinking about it, i would say...

while im used too hershey and carlisle shows, the sussex show alright. i got to meet jatonka, big plus for the day, and i scored a new set of hubs, and a complete set of spin on filters. i installed those today and my air assist steering. thanks jatonka!! also got a great deal on sheetmetal, all...

just got my bobbed deuce insured thru state farm for $64.00 a year on 4b registration. i told them i planned on using it parades and general hauling with some plowing. try them.

are the m135 wheels 20 inch? or 18 inch? anybody?

looking for the m135 wheels how much?

New bobbed deuce info I am just starting the bob job on my newly aquired deuce, and i am using the m105 springs and brackets. Why does it appear that when this is done nobody installs the overload packs? Its only a matter of 12 more holes to drill, and longer ubolts. Also nobody seemed to...