Search results

OK got here fixed. :naner: My local surplus guy had a new original stater still sealed in the box. I got to cut it out of the foam! Sticker on the box indicated that it was packages 12/85. Price was $348 including tax. I wish they were cheaper but it is about the same price as NAPA if you don't...

I appreciate the help with the part numbers. I don't really want to switch over to gear reduction at this point and don't have time to wait on the bracket to be shipped even if I wanted to switch. I only have one day off to get it fixed then I have to go back to work. Thanks again for the part...

Thanks doghead. Sorry about that it is a direct drive. Yea that is the problem that i am running into, everyone I talked to has to order the parts. At this point I think I am going to have to drive close to two hours one way to get one a replacement tomorrow, eat the core charge, and keep the...

New twist on Starter run on ? It happened to me :x 1984 M1009 has bee running fine. Stopped at local u-pull-it found new tail gate crank with the key, a good working, spare tail gate window regulator, and some other goodies for about $30.00 so the day was going great. Went outside loaded...

If the starter is ok except the bendix / starter drive I would like to just replace it myself. I have done it with other vehicles, so it is not a big deal. The problem, I have been reading on here all day. I can not find the part number mentioned any where. So Is the bendix a 9 tooth, 10...

Missing tooth where? Fly wheel? Starter drive / bendix?

Unfortunately I have to. It is my daily driver and only vehicle. I was able to get the front one out today and it is a priority to get the others out. I will be working on that problem tomorrow.

Ok climbed under her and checked to starter bolts and bracket. All present and snug. I did find that all three bolts that bolt the transmission and bell housing together on the passenger side were missing. Strange? Got some new ones and lock washers, installed them, and still having the same...

Yea it is getting in the 30's to low 40's around my way at night and I am having a hard time starting in the mornings. I know part of it is the glow plugs that I am working on but I will cycle it three or four times and still having trouble starting, so I think the heater is a good backup /...

That makes sense. I know not everyone on here is a fan but I am putting in a block heater to help with starting. I work for a small rural fire department and sometimes have to run calls from home. I need it to start as easily as possible in the middle of the night. The problem I ran into is...

Thanks doghead. I am at work today but when I get a minute I will climb under her and take a look at the starter bolts. Sundays are slow at the Fire Department, unless we get a call, so I should have a little time to tinker today. Also, It appears that the resistor has been by passed on mine...

Good morning, I have a new issue I am working on and would like some second opinions. 1984 M1009 I have been having a problem with hard starts when the vehicle is cold. I have put in a new glow plug card, replaced the glow plugs on the driver side with AC 60Gs. I am working on the passenger...