-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
Mep-804a no output. With video
K15 has a diode that initially looks out is place but it's shown on the TM. It goes to K12 and checks out .480 volt on my dvom. After all that, still only 11v at the fuse when S1 is held on start- MAdams
- Post #15
- Forum: Generators
-
Mep-804a no output. With video
Wire 190 goes from S1 to K15 relay. I swapped the relays around but still no voltage at the fuse. The fuse wire is 141. It also goes to K15 and also goes to TB8 (in pic) which then 141 turns into a large diameter wire and goes directly to the generator.- MAdams
- Post #14
- Forum: Generators
-
Mep-804a no output. With video
I do get 24vdc on pin 7 when S1 is held in start. Also, with the battle short switch off, I get 11v at the fuse when holding S1 in start. With battle short on, I get no voltage at the fuse- MAdams
- Post #12
- Forum: Generators
-
Mep-804a no output. With video
I'm only getting 1.2vac on both sides of the fuse. I double checked the mag pickup. It reads 800omhs and 2.5vac while using the dead crank switch- MAdams
- Post #10
- Forum: Generators
-
Mep-804a no output. With video
The fuse in post #4 ohms out as good. I did not start the generator but with S1 in the run position there is no voltage at the fuse.- MAdams
- Post #7
- Forum: Generators
-
Mep-804a no output. With video
- MAdams
- Post #5
- Forum: Generators
-
Mep-804a no output. With video
- MAdams
- Post #4
- Forum: Generators
-
Mep-804a no output. With video
These are the only two fuses I know of. Pic 2 is hard to see but it has an exposed fuse element- MAdams
- Post #3
- Forum: Generators
-
Mep-804a no output. With video
I finally got this generator running after replacing S1 but it has no output voltage other that the 6v exciter. No fault lights, and same results when the battle switch is on. Here is a link to a crappy video https://youtu.be/UzrAwGMIK1s- MAdams
- Thread
- Replies: 15
- Forum: Generators