Search results

I'll send some more pics. Been busy with work. Not much progress. Installing the side with next.

Thank you 1951M1078.

Thank you SteelWarrior. Yes indeed. They do gas off H2S. I have drilled a hole through the battery box and connected through another hole through the shelter. They are all sealed and gas off to the outside. I have measure the H2S levels in the battery box, and it does indeed gas off. I did...

Here are the pics of the Dolly set up Coachgeo:

Hey Coach Geo. Yes it was a DC Powered Electric motor with compressor. There was a 120V plug-in heater that i took out of there too. They all work too :)

Moduline Cabinets prior to installation

Thank you. I can't take all of the credit. I had a couple of talented mates helping me along the way.

Berth platform Again, used 1 5/8" slotted unistrut to construct the berth space above the water tanks and batteries. The bed size is 52" X 80". Used 5/8" Oak (sanded and clear coated for the mattress to sit on)

Water pump and plumbing Accumulator being fabbed on a platform Water pump, accumulator and plumbing shown

Shelter water tanks and Battery Bank Two fresh water tanks 34 gallons each installed on the port side of the shelter. 1 5/8" slotted Unistrust was used where needed. All items were fastened via 1/4-20 Steel Rivet nuts to the structural beams in the S280. On top of the tank I used a 1/4" thick...

Thank you Deoje

finishing the floor with Durabk (Rhino Liner) paint Original Linoleum floor shown below After removal of the floor via heat, chisel and laborious work, I cleaned it with TSP, and mineral spirit. I then put three coats of self etching primer. I then rolled the Durban product. Highly...

Hey OD. It was pretty clean to begin with, but i put some grease and elbow in there as well.

Nice Pic. Thanks Tennmogger. :)

reposting pics Hopefully these pics will get inserted properly

Thank You Overdrive. Sent from my iPhone using Tapatalk

Thanks Coachgeo. I don't know what's going on the attachments showed just fine during the upload. Now I can't see them either. I spent some time posting these items. Oh well I'll do some reserach.

I had to heat the floor one square ft at a time and use Heil tool to remove the Linoleum. It was a laborious process. It took about 16 hour to remove the flooring and fix a couple of holes on the floor.

Sound Proofing Installing Dynamat under the cab and inside.

Generator, propane tank and Auxillary Diesel Fuel Tank Installation I mounted the Honda EU2000 generator on top of the AHU bracket. To its left I installed the tool box holding the propane tanks for the shelter as well as additional storage for tools. Next to it on the right hand side of...