Search results

Some of the guys will let you try to turn the motor over with a socket and some will not. I don't believe the are supposed to let you. But if you can move the fan or crank with your hand more than an inch you should be good. Ideally you would want to make a complete revolution but that may not...

Just to give everyone fair warning, I bought 4 generators from GL in December and the ads stated motor turns. I get them in and 2 of them are hard to turn over by hand. I hit the dead crank on one of the 2 hard turners and it sounds weird so I stop because I bet water got into the exhaust and...

Here is an image of the wiring diagram for the monitoring system. They attached it to the lid that covers the gauges. If you wanted to keep the monitoring harness in place, just jump pin G to H for the Emergency Stop and then O to P for the DC amp gauge to work correctly. I went ahead and...

I have a box of assorted O-rings I use to replace the rubber washers you are referring to. Usually you can find them at any auto parts store.

Demoh, I believe smokem joe was talking about shipping the wiring harness to you for shipping charges, not the entire generator.

More than likely de-modding because I resale all my units. I bet I can just hook the emergency stop back up as stock and the unit will work. So I may leave everything and just do the minimal but I won't know until I can see how they are hooked up.

Just by the initial looks of the set-up, it does not appear to be a remote start function but merely a remote display or monitoring (less complicated). The wires look like they are connected to the AC voltage meter, DC Voltage meter and the emergency stop switch on the panel side. I would bet...

Smokem joe, I've got 4 sets coming in later this week from Lockbourne, with the same set-up as yours. Give me a little time and I'll figure it out, then comment back.

1st try to rotate the motor over a full 360 degree by the crank (hand). 2nd wipe the fuel tank out by hand. Usually a lot of sand and dirt in there 3rd fill the fuel tank and put new fuel filters in. This will give you a chance to see if the well nut leaks. If you don't know what the well nut...