Search results

Thank you! Printed the tm manual, mine is set above the start b/c when it's under and you shut the gen off with the throttle it has so much slack the spring falls off. Sent from my SM-N960U using Tapatalk

Working great! The ground was rusted and I'm assuming that was all the issues! except for the sparatic idle, any tips on getting that right? Such as where the gov spring is? When I kill the engine the spring is so loose it falls off. What's the optimal spring setting, idle arm setting? Sent...

These came from the temp sensor, I thought the temp sensors were attached to both sides of the block right over the ip pump. So I put the wires together and put them on to the temp sensor, turned it on and it burned through the ground strap. I could have attached the wrong connector to it. I...

does this look correct?

Where would it plug in? Do you happen to have a picture of yours?

I am but this generator is really new to me and it makes me nervous, also with no fuel tank I figured it had to be related to the plug bieng disconnected. I do appreciate your help and patience. Last question: mine has one threaded pipe for the exhaust, I looked with no luck, is there a direct...

What is the normal part to replace if the sensors are good?

Okay, I have not tested the wires but the even with the oil sensor unscrewed it did not change the kill solonoid turn the engine off after start, fuel pumps kick on great. I discovered a washer out of place on one of the pumps so due to the advice I got here I was able to fix the broken pump so...

You are amazing! What would you advise trying to test? I tested the oil pressure sensor and it was good and the temp sensor on the far side of the engine and it was good. I am just jumping the terminals to test is there another way or something else that I can try?

The pull out throttle lever increases slightly then it reduces back down. All this is with the solenoid jumped to 24 v

Right when it starts, what is a loss to k1? Can you elaborate a little bit please? How do I check that? Thank you for the help!

I searched the net and the forum and could not find the answer, tested the oil pressure sensor and its good as well as the engine temp sensor? and it was good. My generator has no fuel tank but i'm not sure that that would trigger the shutdown of the engine. I also have read the manual and...