Search results

Yes you did post that earlier, I just now know that I was looking at the whole card and not just a segment. And just a question for clarification, do I need to disconnect everything from the card for the test?

Gentlemen: Frustration is kinda settling in and looking for the test of the A5 card hasn't been found. I don't seem to have the correct name for it. I went through the Card section for repair and diagnostics and couldn't even find a box that resembled what it is located in. I am asking for more...

So I have returned with the report/ After pulling said box I opened up the compartment and found how nice sized a modern day ECM is but with the box open you have the possibilities of repairing itself. I have attached 2 pictures of the A5 Card and I am asking if the R3 resistor would prevent the...

When you say the A27 Box where do I look in the manual for the explanation to the A27 Box? Is there a drawing show =ing where the A27 Box location/ Any recommendations on who to contact for a float?

There were 2 floats on it/ and with s2 in run, the s7 in the up position, the CB1 pushed in there was no voltage what soever at the J33 plug that goes into the Floats

Thanks/ Literally on the very back/

So here is what happened with that test Holding the J33 in your hand, stick in the first paper clip into the A&B pins of J33. This should turn on the pumps, if the wire harness is good between the J33 and the pumps. Then place the second second paper clip into the C&D pins. This is the idot...

Damn your good! I will get back down there and try the jumpers on the plug/

That information on the fuel system is great! First off the handle was in the wrong position. I followed the procedure you outlined so well and I did not get fuel/ The pumps never turned on/ So I dropped the strainer bowl and removed the strainer (now in your procedure you said to removed the...

Thank you/ I printed it out and I will give see what gives tomorrow. I have a path I am following now.

So I read how to do this and Guyfang stated if this didn't work to write back. Well it didn't work so I'm back. I put new seals in the filters/ Did as per Operators Manual said /Switches and lights worked as mentioned/ No fuel Afterward I looked on the electrical schematic and decided there...

Well, thank you for the response. The instruction was invaluable. The rebuke was noted. And to answer your question, No I hadn't looked in the TM's but now I know in which issue to look. Thank you Guyfang, Lugnuts

MEP 005A Thank you for the reply

Gentlemen: About 2 weeks ago I had a generator load up with water on the fuel side/ So I removed filters, drained the injection pump, cleaned the lines and checked my diesel supply ie I cleaned the tank/ So I went to start it and it seems I lost prime and need to replace the quad rings at the...