Search results

No, the recommended the smaller one and then I got the bigger one on accident. But they said that it should be fine. There's a simple formula they use to calculate what size unit to spec, and it has to do with the percentage of oil in the system. Sorry, don't remember the numbers off the top of...

You ought to give the people at Spinner a call regarding sizing. Talked to them a few times and got a lot of helpful info.

You could always run an electric oil pump.

Do the oil analysis! It only costs a few dollars and we'd all like to know...

I asked the people at Spinner specifically about jarring off-road, and they said it would not be a problem.

I'm not sure what you're asking? If you're asking about the Spinner II, it never needs to be changed. There's no filter element. You just clean out the bowl periodically. With regard to the oil, I'm installing a brand new (rebuilt) LDS in Mah Deuce, I'm filling it with Amsoil synthetic...

The benefit is that these Spinners filter down to less than one micron, and there's no filter element to change. I was planning on installing a second centrifuge in my trailer, so I could filter oil/fuel, but now I'm wondering whether I might be able to plumb the one Spinner into some type of...

Yes! It's a bypass filter, meant to be used in addition to the regular oil filters.

No, I decided to wait to install the Spinner. I bought an LDS engine that I'm going to swap into Mah Deuce (just got home with it last night!), and I'm also going to install a RACOR CCR and primary fuel filter in the same area. So I think I'll probably be able to make a one one mounting bracket...

I spent some time this afternoon trying to figure out where I want to mount this Spinner II unit, and I ended up designing a mount very similar to JDToumanian's. The bracket is about 15" tall and it's offset to keep the centrifuge away from the turbo. The pictures where I'm holding the...

Oh, and what size oil lines did you use? EDIT: Just checked and the instructions say to use -8AN.

Thanks for sharing. I just got a Spinner II 960 for mah deuce. You guys think that's going to pull too much oil?