Search results

Rango - I am about 2 hrs east of you, but have one for sale. PM or email me.

If you need it, the OP has after market replacements for sale. However, you might want to verify the settings and setup thoroughly before declaring your system as inop. One of my M1031s had an issue and it turned out to be a jumper wire some monkey installed from a hot 12v to the gov actuator...

Well, the tm lists the following specs for the air compressor motor: Motor Spec . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35S69-1342-MOO Manufacturer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

Muncie told me to use a distributor and sent me a list of them in FL. Part number: 31T35108 If you ever need the mag pickup, you can email Muncie for distributors in your area. I think I have a bad one, but am going to try swapping parts from another truck before I spend $80 on a new part.

I do agree. I would not run your house from it during an outage. If you want to convert the generator to single phase, you can use the attached manual to figure out the wiring changes needed. This would be in the generator housing. See pages 9 & 10. I would choose diagram G which gives you...

Did you guys rewire the generator or just the panel innards? I know the actual generator can be rewired for single phase as opposed to the stock 3 phase setup. If only the panel was rewired, you need to watch for out of balance conditions as it may cause some damage to the generator.