Search results

I used right stuff on the pan thiis time as well and it works awesome. It is not leaking on the pan this time around. It still appears to be leaking from rear main, but as said before i can visually see oil almost bubbling out of the gab between the bell housing and block on the starter side. I...

Well, rear main has been installed for probably 2 weeks and it is still leaking almost as bad as before. I followed the tm exactly using anaerobic sealant on the main cap where it recommended and a small amount of pipe sealant in the seal groove on the main cap. Also offset the seal by ~1/2". I...

I checked the back of the engine pretty well with a mirror but I will look again tomorrow. I felt all along the back of the heads etc and it felt dry. I looked at the rear main pretty close both times and even now it looks dry. There is no oil on the flywheel itself, just running down the inside...

Ok, did the oil pan again. This time i used permatex right stuff, which was a very good product I thought. I let it idle for an hour after the job, then took it for a drive and no leak. Today we were heading to a jobsite and got a flat tire. I had to leave the truck and get a jack and spare and...

I apologize ahead of time for the long post When I first got the 1028 home I noticed it was dripping oil pretty good from the very front edge of the oil pan where it is turned down. It was leaking pretty good and after researching here a good bit I decided I would check the cdr first. I pulled...