Search results

I bought the 50 sq ft roll . It seemed to be just enough . I made sure to measure and cut every piece and use scrap pieces where ever I could ! The 100 sq ft roll would be over-kill and a lot of left-over material .

Yup as the project goes so will the pics, I should be able to finish Tues or Wed next week ! I'm also hoping the Zilla is not too thick to skin the insides of the doors ! I'll let you all know !Everyone have a great Memorial Day weekend ! I've got to work Sat at the range , and Sunday doing a...

Thanks Yellobronc, for your input . Mark , I need to get into the doors to skin the insides . The driver door is a little problem in that the window when rolled up doesn't align properly . Gonna get a new regulator and window channels to see if that works. I've got the hard top so there are some...

Mark , I've taken a good look at the belt routing . All I can say is the water temp stays consistent (on the road) and the generator shows charging !..Bob

Mark , the unit I got from Boyce , really pumps out some cold air. The problem with that is the cab of the deuce isn't insulated and has numerous points where engine heat(hot air) enters the cab . During this project I'm sealing up every little hole where that hot air can enter . You noticed the...

Yup , that is a/c hanging under the dash . That was the priority in insulating the cab , keep all that engine heat outside instead of inside ! Had to think about how to get to things if necessary , you can't see it in the pics but the trans tunnel and master cylinder access are seamed to open up...

The liner is called Zilla Mat , I used their 80mil thick product . The floor mat is just a stall mat that is 1/2" thick . Very sturdy and durable . Should last quite awhile .

It took awhile to get the time to start this little project , but I did get half the cab insulated and added some rubber floormat to it. I guess I'm a little more thorough and wanted to get it right . Here's some pics so far. I will be able to finish the project next week. since it's well into...