Search results

Thanks. I the defroster duct was not punched-out, so I drilled it. Done. The passenger-side dash support went right in without any trouble, but the driver's-side is vexing me. There are two sets of holes in the firewall that have the proper spacing, but if I bolt to the lower set the bracket is...

Thanks. There wasn't any rubber on my front fenders at the front or rear mounts, so that's good to know. Best guess is that rubber is about an 1/8" thick at the front, and what about at the rear? The cab doesn't actually sit on any springs, it just has springs that allow it to pull away from...

Ah, so I need to drill a hole through the heater duct and then shim so I can bolt through the whole shebang. Great. Thanks. Orientation of the steering column supports has got me scratching my head. There's a reinforcing rib on the firewall that's preventing things from lining up properly. Oh...

Wondering about that top bolthole in the dash, and how close the heater duct is behind it. If I trim the bolt to the perfect length I might be able to get away with squeezing a thin jam-nut in there, but it doesn't seem right. Dash is straight. Maybe the heater duct got welded into the wrong...

Ready... set... Go!

Went down to Agri-Trade in Salinas and picked up a bunch more misc. parts, and I don't remember where half of these parts go, so there'll be a lot of chances to help/enter/win.

Sure, there are a lot of holes left on the firewall. Tell us all what goes where. Doesn't even have to have anything to do with my truck. General info about why there are holes and mounting points here and there is good general information and am sure someone will find it helpful.

Gotta add some value if you wanna win. Thanks! That was easy. Still need to know where they should pass-through the firewall. Might just end-up making my own holes because I don't think this cab was configured for a multifuel, but would still like to have some pics for reference. Know I could...

Cab is not sitting level on the chassis. Why? Will take a picture of the rear cab mounts to show that it's assembled correctly. Pretty sure about that. But there are supposed to be rubber pads in between the cab and the chassis at the front mounts, right? That's just going to make it worse? How...

Firewall on the engine-compartment side. Any/all holes and knockouts are fair-game. ****, even the air-filter housing...

Help me remember what goes where. Know those two empty holes on the far left are for the engine kill and hand throttle, but which one goes where, and where are they supposed to pass through the firewall? Can't find a plaque that fits in that space under the procurement tag. If I remember...

First question: here

Putting mah deuce back together and I was pretty good about bagging and labeling hardware and everything, but there are a few things I can't remember and it's a new A3 cab and a bunch of other new parts, so it's not going together exactly like it came apart. Mostly just little things, like the...