Search results

JD 4045 is common motor, any farm JD will have the rubbers in stock, I dont have the numbers for them, there are 2 different sizes, I have had to replace every mechanical pump due to not being able to hand prime or sucking air. any serial mouse will work as a temp replacement to the key pad. if...

if its a fuel issue, replace all of the rubber bushings between the collar and fuel lines on the suction side and at the injection pump.

I only loan the tool, its a $300 dollar deposit, the deposit minus actual shipping costs, gets refunded when the tool is returned undamaged.

The video shows with contrast full light. Does that what you mean by in the sun too long? now the bubble is a physical fault so only way to fix that is maybe pull one of the layers or replace the screen

Color or monochrome? here is the video of the tool at work

@TheAlfredo, are you asking if the display is repaired or if the bright/dark tool got built? answers are yes and yes

Which cable did you trim? the 100 wire ribbon that the connector from the outside? the other screen control cable is the 8 wire connector that connects on the same board as where the power connects to.

Delay of game, shipper sent me a 50 pin cable, not 100... well this project gets set back on the shelf. I guess if you count both ends, he did send me a 100 pin cable.

Ok, finally took the time to look at this thread and figure out how to build this without getting the wrong wires..... https://www.steelsoldiers.com/showthread.php?167187-MEP-805B-and-MEP-806B-CIM-(Computer-Interface-Module)-Brighten-Darken-Information so we pushed the ez button rather than...

What is y'all's opinion on putting a couple desiccate packets in the case?

OK, I have a head scratcher. This was the screen I got after replacing the screen, I had swapped CIM's with another 'B' that I have, and it worked just fine, so I stick the original back in, still no go, soooo it sits on the broke line waiting its turn to get back in the shop. I go out today...

When you get your new screen you will have to replace the metal back from the old screen to the new screen. Reason... there is a heater on the back of the old screen that was glued on and I couldnt get off. It was simple, six itty bitty skrews and 4 bend tabs. Also including a photo of the pn of...

Luckily, I do have another 805B with a very good screen, looked new to me, so now to just find a computer nut to pull the fill out of 1 and put it in the other.

I wondered if there was a different driver for the different screens, only reason I got an exact pn replacement, see if that helps things, if not.... well i have a spare screen.

delete please, double post

I did replace the screen with a China version but now I get this screen if you cant read it.... it says 'Unbootable device available r- reboot s- setup esc- bios debugger' I did not use an exact part number replacement, the one I used was a direct replacement. So I ordered an exact part to...

When I get my new display from China in about 2 weeks, I will do another write up to show assembly/disassembly for those of you who might need to do it.

I started to play with my 805b the other day, and notice some moisture in the display. Removed box from genny and took it to the shop to 'have a closer look' As I was carrying it to the shop, water was dripping out of the front glass, well thats not good. Get to the shop, take the back off...