Search results

She is running!!!!!! :lol: JBK you were right, the fitting under the TEE was pluged solid with gunk. it cost me $7.46 for a new TEE and a close nipple to connect it to the IP. I did find a leaking return in the cylinder closest to the radiator. i will pick up a net TEE tomorrow since the...

ok i will go try that. it is located at a storage lot about a mile from my apartment and will try it after dinner.

I also replaced the final fuel filter. good news is it matches the deuce filter. when i took the can off the gasket was all mangled. i put a new element in and a new gasket on but it did not change anything.

It does have voltage to the solenoid. jbk: do you have more details on this glass ball? where it it located? Thanks Rob

Is the solenoid on the injector pump a powered open solenoid? Could i put 24 volts from the battery to the solenoid and check it to see if it will keep running?

I will check all those fittings as well. I have great oil pressure, it comes up on the short runs.

Update: Today, i took off the injector lines and they were clear. I reinstalled them and bled them. I checked the filters. checked all the fittings. I then started it and it ran for about 30 seconds and sounded great. Then it stopped. i tried to restart it and it will run for 5 seconds at a...

i did give it a shot of ether and it ran for a few seconds then died. i will check the filters. they don't leak and i get good fuel out of the drain ports on the bottom. i cracked open the fuel line at the IP and had good flow their as well.

I purchased an MEP-004a on Dec 29 2011. It started up after about 10 seconds of cranking. to previous owner had not used it that often and from time to time he said it was stubborn to get started. I went to start it today after putting brand new batteries and all it does is crank. i am getting...