Search results

I had some tailgates that had hinges bolted to the tailgate. This may be why.

Ive see them bow from the hitch. And twist when only one chain is hooked and too much weight put on open gate.

I usually tell them its for a custom ratrod. Luckily i found an actual hotrod shop nearby that can help if i need to find a special service.

I am trying to figure out why the little gauges are different colors. I doubt I am ever speeding at night, so I don't need to see mine that bad.

There is a setup for an electric winch in the rear. It uses the newer style front bumper with big hole, and other brackets.

Wipers..... Remove bolts holding wiper motor to w/s frame. Pull out as much as you can. Remove nut holding linkage to the motor. Turn wipers by hand to other side of w/s. Put linkage back on motor with nut. Put motor back on w/s frame. The linkage only fits on motor in 2 positions, 180...

A 4-speed would make a quieter ride at higher speeds. Not from the transmission, but from lower rpm of the engine. As for noise...do you have all of the factory tunnel and floor pads in place? There are also 2 black rubber pads that fit the area around the washer fluid tank. Is the inside...

You are adding extra wherl weight but removing the runflat weight.

It wasn't easily repairable for the radiator repair guy !

Those short doors ate standard on the armored 2-man trucks.

About 90 psi of air will free up the clutch. i have used 1/4" quick disconnect fittings for the air,

12341792. or you can order some similar rivets from fastenal. the back spreads in 3 directions..

Did you tilt the HMMWV steering column all the up first to see if that helped. They can go quite a bit up and down.