Search results

Got any pic's or diagrams or even crayon drawings of this setup for us electrically impaired folks to look at :roll:

Speddmon wrote

Back out the center bolt that holds the blower to the shaft a few turns so that it not touching the blower then position the tapered puller shaft on the little counter drilled hole on the bolt ( its there for that purpose ) tighten up on the puller jacking bolt and then (as Spedmon said) tap the...

Heres my old/bad (shorted ) stator Darn thing looked brand new, the ( used) stator I bought to replace it with looked so bad in comparison that when I went to reassemble I grabbed the old one and started putting it back on :doh:

Just in case your second (used) VR is bad too. I also bought my NOS VR from Eriks Mil Surplus Voltage Regulator/Rectifier (Battery Charging) For Onan MEP-002A / MEP-003A 5KW and 10KW Generator Sets, FVR4006

When my genset batts sparked when I hooked up the batts I went and pulled off the capacitor because from reading past post the sparking was bad only to find out recently that it was suppose to do that ( thanks PeterD ) however my capacitor is still disconnected and my genset DC system is still...

Did you check the fuse holder? My fuse was good but the spring wire inside the fuse holder was bad and not making contact with the fuse, Just throwing it out there