Search results

Ok, Thanks guys. It seems like it was just a coincidence that it didn’t go wide open after I unplugged the high idle solenoid because it has still done it a couple times. It only does it if I have not held the glow plug button long enough and have to crank it for a while, then if I pump the...

I checked the regulator and it was not holding the throttle so i figured I would disconnect the high idle solenoid and it started and idled normally, so I guess that was somehow causing the issue or the issue fixed itself somehow. Since it was running right I waited to see if the glow plug relay...

Ok, thanks. I was a little concerned about the glow plugs because on my other cucvs it clicks off before the light goes out. I was unaware that the regulator could cause that, but I will check that. I’m always learning new things about these trucks from this site

I recently purchased another project m1009, I put a new starter relay in it and it started right up, but always needed the block heater for it to start. It sounded like the glow plug controller was bad because the relay was just clicking on and immediately back off so I wired u button into the...