Search results

I would advise against using a hammer to tap it on as this puts lateral stress on the crank bearings and can ruin them. You might try putting the balancer in the oven and heating it up to make it go on easier, but most of them will be too tight to be able to "tap" onto the crank. There is a...

the installer sets at all the major chain stores do not have the proper thread pitch adapter. i tried calling them all :) just finding a proper bolt was bad enough. if you have a fastenal around you they can order you one. after a new balancer my pulley still wobbles a bit. i suppose it's...

It's a fine thread 16mm bolt. I was able to get a 10cm long one from fastenal and a couple nuts and washers to use as spacers as I threaded the balancer back onto the crank.