Search results

Good to go!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Guess we shall see.

Test the fuse, in the Quad MWO. Is it good or bad. If it bad, replace it. DO NOT just jump it. If its bad and you replace it, and its popped again, your volt reg is bad. If the fuse is good, and you still get 25 VDC after starting, you need to check the Main gen winding.

When does the 120 volt outlet have 25 volts? During start up? After you let go the S1? Do the meters come up? Then go back down? Or never even move the whole time? If you are getting 25 volts, (and its DC, not AC) then you are getting excitation, but the main gen will not light itself off. Does...

Do you get a fault light?

Look at post #13. Jamaweib says it all. Normally the set will not start without the K20. How are you starting it? There are ways to cheat the safety chain, like any other electrical device. If you know what you are doing, you can start and run the set with no relays. But they are there for a...

Can an you read a schematic? If so, you could use wire to jump that circuit. Would I do that? No, not unless it was life or death situation. Because if you get it wrong, you could do much damage. Or if you had no oil pressure, the engine could destroy itself. Not good. Like LITD posted, your...

Put these numbers in the big auction site. Cost 24.00 5945-00-458-3351 KUP14D15-24VDC

Now if it were me, I would look up the relay, and then buy one.