Search results

The Dorman CV boot spreader works great on the more flexible CV boots. Here is what happens when used on the heavier duty military grade CV joint boots. The manufacturer recommends 90 PSI for use. It wont even begin to spread the heavier boot at that PSI. I even tried to heat the rubber boot to...

After a bit of research is does appear that the half shaft that I replaced the boots on is in fact a 7K. The other 3 had been replaced and upgraded to the 10k half shaft. I'm grateful for the information received from you . Thanks again.

The Boots were purchased from SECO Parts : HMMWV HUMVEE M998 M1025 HALF SHAFT BOOT KIT 5705605 NSN 2530-01-191-8741 ( 163461050964 ) My HMMWV is a 1989. This axle I was assuming is a 10k. The large outer hub is round. The other 3 axles appear to be upgraded as they are different. They seem...

I replaced half shaft boots. I did not want to disassemble half shaft to install new cv joint boots as only the boots were torn. I replaced boots with new old stock. These boots are much thicker than aftermarket boots. I spent two hours trying to use the cone method in trying to install cv...