Search results

Well, that's great. Currently, I do not have it hooked up correctly. Hopefully the control module will work properly when I do get the proper configuration. Otherwise I'll just have to order a new one. Thanks so much!

That's great! A photo would be nice. Does the ground wire going to somewhere else attach to the same screw head as the 6 inch wire? I ask because there's 2 screws on the back side of the control module. I was thinking the 2 scenarios would be the one listed above or each wire gets attached to a...

That's good insight. Thank you. One more question...When I disconnected the ctis cm there's 2 ground wires that screw into the back side of the terminal. One ground comes from somewhere in the truck. The other ground wire is about 6 inches long and is just independent/ by itself. I forgot the...

Hi. I thought their may be a leak but I didn't hear anything. I used the liquid leak detector on all the fittings I could find. However just prior to the system discharging it's extra air, I do hear a hissing noise. I don't know if that sound is a leak or just the air going through the system...

I took the rim off of the tire and found that the run flat wasn't lined up with the valve stem. I knocked it into place with a dull chisel and hammer, cleaned the Ctis apparatus of oil, and hooked everything back up. While the tire was still jacked off the ground, I started the truck and set the...

That's good to know about the Krytox GPL205 grease. The next time I grease everything I'll use it! Thank you

When I replaced the tires, I also replaced all the old seals with new seals and I greased all of the bearings. I did replace some of the plumbing fittings. Instead of the cork, I used gasket sealer in the green tube to fill the little cavity. However prior to this maintenance I did see...

Thank you so much for your reply. Cold weather/-40 degrees may have caused the problem with the CTIS system. Last winter, I started the truck to air up one of the tires that went flat. The CTIS control module started behaving differently after then. It won't shut off and won't bring all the...

I'll try cleaning the ctis valve. Good idea. I thought that I might have not got the run flat lined up with the valve stem when I replaced the tires. However my CTIS control unit won't shut off when I hit the off button and it won't air up my tires beyond 32 psi. I'd like to bring it up to 45...

I just put new tires on my M35a3. The CTIS system was working fine. I aired up all the tires to 60 psi. I drove 6 miles and checked the air pressure in each tire. 5 of the tires, are reading 32 psi, but the front left tire is reading 60 psi. The CTIS is running its cycle but is not brining the...