Search results

Years ago when I did mine I offered it but there was little to no interest so I ended it. So sorry I don’t offer anything.

The seats were purchased from the online auction site and they are dodge caravan second row bucket seats with arm rests. I’m guessing they are take outs from when they do the van conversion for handicap vans. I made the boxes out of 3/4” Star Board. I made the liners using the material from...

Here are some pictures of the almost finished interior.

I purchased all the insulation and floor mat material from www.cabinsulation.com Check them out. The floor mat material matched the original LMTV floor mat material. I’m guessing they may be the supplier to LMTV manufacture. All the insulation is soft foam. Using the metalized mylar first again...

My latest update involved replacing the Gen1 dash/evaporator unitwith the newer Gen2 unit. After trying everything possible to get it to blow colder air. The gen1 unit struggled to blow 60-65 degrees on a hot summer day here in Florida. Which doesn’t cut it. So in goes the Gen2 unit. Now it...

Great job, looks awesome! It’s a lot simpler than sourcing out all the original brackets and such. Thanks for posting all the pics and info.

Sounds great!!! Can yo post pictures of your compressor and condenser?

The condenser will work on Gen 1 or 2.

SPAL va18-bp70/ll-41ms 24V FAN , CNFP1623KT Kit AC A/C Universal Condenser Parallel Flow 16 x 23 O-ring with Drier Her are a couple changes I've made that has improved the temp coming out of the vent, it dropped the temp from 60-65 down to 48-52 degrees and much cheaper way to go. I purchased...

Here are a couple pictures with the cab down.

I haven't seen any additional mud or such get into the engine compartment. I'm in Wauchula.

I'll try to help out with the wiring but understand that this is based on my Gen1 Evaporator unit and that you should only do this if you are qualified and fully understand the system. Don't take what I say as fact for all circumstances as yours may be different and you should always verify you...

The amount of refrigerant is relative to the size of the system. First taking it to a local shop that put 8 lbs in it and not being satisfied with the results. I contacted red dot who felt that was to much and recommended a specialty AC shop 70 miles away in Tampa which specializes in custom AC...

deleted the duplicate post.

One step closer. While trouble shooting the AC this morning before the sun was up, I wanted to verify the thermostat was working properly. The thermostat is factory set at, off at 31 degrees on at 39 degrees. With the volt meter monitoring the voltage coming out of the thermostat so I could see...

I'm sorry but I believe it is possible! If you look at my installation you will see I'm not using the factory condenser and it's located in a different location. Also I'm comparing it to my 2003 Cherokee parked right next to it, in the morning before the sun comes up and the Cherokee will put...

After seeing and talking with others on this site about their AC cooling performance not being what we expected and with very similar results on out put temperatures. There are only a few main components to an AC system such as the Compressor, condenser, drier, evaporator, and the expansion...

Anyone near Wauchula, Fl with a M1078 A0 / 3116 engine that would like to do this type of AC installation and has the main components? I would be willing to prototype and build the kit and only charge you for what it cost me to make the parts. I would also HELP install it for free. Although, you...