Search results

Looks great!!

Will your Winter/Summer Valve operate?

I know I asked about your dash lights, the high beam and turn signals, but can't find the info?

I'm using Gamma Goat lamps on the rear, full red lense. I'm not sure what wire is what yet, I figure it out soon I hope? The wires are marked 21/22/460-461 and they are the same as regular M-Series lamps.

Rear light question, what are you using for tail lamps?

Like it T, looks like you & Rob are getting up the pace.

That's a darn good idea for the turn signals!

Progress Your right about that! I finished my steering wheel, finally!

I've driven down my driveway a few times to get the mail, it's 1/2 mile each way, the smile gets Bigger each time! ;~)

Working Pump Well the stars aligned and the od godess is mobile, I wish I had done the electric fuel pump earlier! I am going to tweak the fuel pick-up a little. Thanks everyone for your help and advice. Regards,

I couldn't even get it started w/ the mechanical pumps, even priming the pump. (physically filling the bowl) After rebuilding the carb, it ran, but would not idle, replaced the throttle body, then the pumps, now I'm hesitant to move forward..... it will happen, just need another pair of eyes on...

Just the electrical pump, I am to chicken to try it out/finish the wiring!! I installed the last mech pump and plugged all of the inlets/outlets rather than making a patch for the hole. I really want/need someone to have a look at the way I have wired it, afraid I'll fry the pump, I am!

Well I really like the way you tank filler is built up, mine is still being held in place w/bungee cords! I had added the mechanical Carter pump and then one from John @ midwest, now the 12 volt Carter and a Melnor fuel filter/H2O separator. Now to wiring everything!

Sounds like good news, I am doing similar things, hoping my wrist improves, so I can double-clutch again!

John probably has the step bolts, did you ask him?

Are you going to add the vent line later? It really makes a big difference. I just added fuel to my renewed tank, also adding some sea-foam tomorrow.

Sweet Job! They turned out really nice.

Great progress, Your fuel tank is a lot worse than mine was!

It's doable, but I took my bed apart on the frame, it was easier for me, working mostly by myself. [thumbzup] JMHO,

Grind those screw heads off, then drill 'em out afterward, that's what I did. BTW, Your GF cannot fake that stuff, she sounds like a keeper!