Search results

Congratulations! ! I can't wait til you get it mounted !!

I believe it would be on the verge of overkill but should more than handle the task .you figure most small to medium tractors have a engine that size.

I understand. I ment 240 single phase. brain fart lol

I have a 208 hydraulic power unit. Not sure the flow on it but it was bought for a 5" cylinder to operate. It's about 2 ft square and almost 3 feet tall.

Gotcha! ! I use my JD 710C to do most of my lifting because it's a royal pain to get everything unhooked on my m816 so I understand.

I like the concept. But with the box on the back were are you going to put the stuff you lifted with the crane?

What's in the big box ??

Sounds like it will be a neat set up. It's to bad your loosing the 6x6. But understand wanting to use the mk15 rears for higher road speed.

:popcorn: I can't wait to see this 1 come together. Are you planning to reuse the m920 rear axles ?

The hwwmv kits came with very basic instructions. But not like charge amounts or were to wire up the harnesses. But it wasn't hateful to figure out.

Looks good. I have done 4 alternator swaps in my m920 and they are no fun !!! The 1 bolt seems easier to tighten the 1 from the bottom. But it's a back and forth thing.

He is a lucky man then !!! I had to do about $900.00 in upgrades to make mine work without smoking anything.

I put 1 of the red dot 24v ac units from a hmmv in mine. Between the fans and blowers it turned my alternator into a crispy critter. I had to do a crazy setup ( step up box with a 200 amp alternator)to get enough 24v for it to work properly. If I would do it again I'd find a 12v unit and not...

Are they 12v or 24v ??

Looking Good !! I bet it hauls Butt with the 1600s I know mine does !!