• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. R

    HMMVW starter Bendix stuck in flex plate

    Great stuff! Exactly what I needed to know. Overhead rig with that lifting hoist sounds like the way to go. I appreciate all the help.
  2. R

    HMMVW starter Bendix stuck in flex plate

    So I've been working on this a little bit at a time over the past couple of weeks. I'm stubborn and see other posts where guys had seized engines and water on the cylinders and able to bring them back to life. I've narrowed down some of the water in the cylinders to rain water leaking in...
  3. R

    HMMVW starter Bendix stuck in flex plate

    Following a couple of suggestions above, removed glow plugs and put MM oil in holes. Did this twice over the last few days. Engine turning by hand is getting easier. A few days ago, i tried the starter and water shot out of the driver side gp holes. It only spun the engine 90 degrees before it...
  4. R

    HMMVW starter Bendix stuck in flex plate

    Well, not so good news. Started turning the engine with a pry bar on the flex plate, and it was moving pretty easy. Half way through a revolution it stops dead. Took the glow plugs out, belt is off, rolled it back a few degrees. Tried again, and it rolled a little further but another dead stop...
  5. R

    HMMVW starter Bendix stuck in flex plate

    Yes it's a Mobile truck. It's not missing any parts that I've seen, but looks like they replaced the generator in 2015, newer start switch, and the light switch was replaced. May be a good or bad sign.
  6. R

    HMMVW starter Bendix stuck in flex plate

    Update... I was able to get the Bendix to retract after putting pressure on the flex plate. Better news, I was able to get the engine to turn! Given the Bendix was stuck, I'm thinking either drop it for a bench test or try a start cycle and see if it repeats? I appreciate all the help!
  7. R

    HMMVW starter Bendix stuck in flex plate

    I did try to push the gear back with flat head and again tapping with hammer. I ran out of time today, but I will try get the engine to rotate. The troubleshooting tm said to remove glow plugs before seizure check.....which was another box on my list. Thanks!
  8. R

    HMMVW starter Bendix stuck in flex plate

    Hello everyone, My first rodeo, so I appreciate all the help. Just received my first hummer 1097A2. During my initial check, when I crawled underneath I found the starter Bendix still engaged. Based on the picture below, my gut tells me not to even hook up the batteries, drop the starter and...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks