Search results

There is only one sensor in there, you literally cannot miss it:) remove the cover circled in red. You can use an ohm meter to check the resistance between 200-400 ohms… I think this diagram may be in error as to what the sensor actually looks like as I have seen other diagrams(I think in the...

That is where the trans wiring harness connects to the transfer case internal pigtail. This connector is on the front side of the transfer and if dirty/corroded could cause you speedo issues. The access cover for the sensor itself is around on the backside of the transfer case. The sensor is...

Yea, I don’t think there is anything about checking output voltage in the LMTV manual but it is easy enough to do. Most MPU,s should be able to make 2.5VAC pretty easilly.

That one is all the way back in the transfer case. On the back side there is a flat plate cover held on with bolts. It’s in there where it can sense a final output gear RPM. That sensor lookes like a key you would use to wind a clock…

Guyfang, He mentioned it down in the pics. You screw it in till it touches a tooth then back it out 2 turns. You need to look inside the whole though and make sure you are directly over a rooth and not a valley. That sensor is pretty wide though so this might not be an issue with this...