Search results

12VDC Pump Here is a picture of the pump install. I attached it directly to the sub-frame I built so I could unplug the battery disconnect, disconnect the controller and lift the entire bed and sub-frame off the truck if needed.

dump costs elkhunter, My dump hoist was a bit over $2000 and had about $5-600 more in steel for the sub-frame, weld wire, gas, paint, bolts, hydraulic fluid, etc. I worked on mine over 14 months and did the bob first which too much longer then the dump install. I don't have any idea as to...

Bobbed M35 Dump Conversion Almost Done I have almost completed my conversion. I used a Scott Level Lift 500DH which came with the hinges and 1-1/8" PINS. The hinges were a bit smaller then I expected and would have gone with larger had I built them myself......which I would next time. They...

Yes, Yes, Yes.....What I have is a pump that mounts to the PTO output of the transfer case directly but since it is for a different transfer case it is no good to me. I will probably go to a dual output PTO on the transmission and then install a pump behind that. Thanks for the correction...

M16ty Thanks for the info on the PTO. Since it did not fit I will be needing to sell it so I can buy the accessory drive for the winch PTO and it is good to know what it goes on. It has a pump for lubrication on the side of it which I would assume would draw oil from the t-case and lube the...

Gringeltaube, Thanks for the welcome and the pictures. I was thinking that the accessory PTO mounted to the cover plate location but it looks from your pictures that it mounts to the rear which makes sense and of course would fit that way. Very cool......now to find one that is affordable...

Thanks for the info and the web site. Looked it over and you did a nice, neat job. Where might I find a picture of the winch and accessory PTO mounted under a M35. I can't get my brain around it fitting but I have not seen an accessory drive in person either. There is not much room under...

M35 Bobbed Dump Conversion Folks, I am still pretty new to this site and fairly new to M35's. I tried a few posts awhile back and they got lost so I will try again. I am in the process of bobbing a M35 and adding a dump bed. I have cut the chassis down 32 inches and cut the bed (drop side)...