Search results

Hey tater6... Did you trace the problem to a bad wire or something?

Yes... Unplugged the connection and it started working... Did you figure out what the problem is/was???

I'm still working on it. Been busy. Haven't had alot of time to mess with it. I do know that it i not stuck in gear. I just got 4 new batteries and ordered a frame solenoid. Should find something out first of the week. I appreciate all the input.

Did have codes. I will post them later. Not at the house where I have them written Down. Really think trans is stuck in reverse.

The starter engages the flex plate but engine won't turn over. Not even by hand.

Yes. The shift button control says NN. It's been a pain in the butt diagnosing. Thanks for your help

Thanks for the reply. I will definitely give it a try. My latest issue is that I think the transmission is stuck in reverse. It won't allow the engine to turn over. I load tested batteries and starter. Tested wtec and tcm. All are good. Engine is not seized. bearings are good and not...

Thanks for the reply. There are 6 fuse links on the drive end housing of the alternator. It says in the fuse link installation instructions that if they are not installed that it could cause severe damage. Are those the links you were referring to? I don't know of any other fusible links on...

Hi. Did you ever figure out your charging system problem?

New to the site. I have a m1078a1 that has electrical problem. The gages on dash stop working.. oil pressure, temp, speedo, and 24 volt gage. The problem is intermittent. Sometimes it will work and sometimes it wont. Any ideas?