Search results

Thanks for the assist So with the S1 in Run - I'm getting 26VDC @ terminal "I" of M6, confirmed that M7 mounting bracket is connected to chassis ground. The voltages of the Temp Sender terminal were 7.5 VDC and decreasing - so I'm almost sure sender is good. However with those voltage...

Just saw so will try next, I did find a previous post regarding testing temp sender and it started off @ around 330 Ohms then decreased as the temp increased which would make me think sender is good & thermostat may be stuck open or missing. " Check TM for testing procedure.....bottom of post...

Good Afternoon, Got back to working on things after holidays - thinking I may have a bad temp sensor or thermostat is stuck open. Checked continuity from connector on MT6 to the "S" Terminal on the gauge and its good. I did swap out the temp gauge as well with same results (no temp)...

Thanks

Once I get the guages all up and running - i plan to run for 30mins to an hour to get her nice and warm before I drain & change out fluids/filters.

Thanks Zed - can you tell me what numbered wires you have going to your red and black wires on oil pressure sensor/switch? Do you know If my coolant gauge is not working correctly if that would prevent genset from running? Since it has a high temp shutoff im not sure if it needs a signal (low...

My oil pressure is fine, just my temp gauge is not working. You don't happen to know which wire goes to which by chance - I'm having trouble locating those wires in a diagram. Thanks

When I picked up - jumped started right up with only 16hrs and I noted all the gauges were operating in normal range, however when I got home some 3 hrs and many bumps / train tracks later - I replaced the batteries and she started right up again with everything looking good. After about an...

Just received a nice 2008 MEP-802A - it starts and runs fine however there are 2 wires (labeled in red 126A20 & 143C20) that were not connected to anything (on the fuel side in the white wiring). The wires were initially frayed like they rubbed apart that I later clipped clean. I'm curious if...