Search results

I put the gen back to 3 phase. All the wires were correct for the single phase mod. The only wire I did not move was x12eg16n as in 3 phase t12 and t11 are electrically the same. It works in 3 phase. So where is the issue? Did someone previously wire something on the reconnection board to the...

Removing ground from L0 should not have had any effect like this correct? I cant read the little diagrams in the manual that well. They are very small and blurry. From what I can tell though everything looks correct as far as the 3-1 phase mod and VR box.

It has always had the unit listed as 30k and ran fine with it. I just don't know why all of a sudden it will no longer produce power unless the switch is held in start.

I got the box out. Not in a fashion I would prefer. The internals look good though. Nothing is smoked. Capacitors look good. None are bulged or leaking. I am again at a loss.

According to the -34 and some threads I finally found on smokstak it sounds like the problem is in that voltage regulator box. How do you get the cover off that thing? There is no room to get to the screws on the side and there is not enough clearance to get a socket on the bolts holding the box...

The last time I ran my mep-004a last summer it ran fine. This spring I converted it to single phase following the instructions in sewerzuk's thread. I gave it a test run today. Starts up fine and volts/hertz come up right away. As soon as you let go of the run/start switch though the...