Search results

Thanks suprman! Give me a couple of days to get back over to work on it and I will take a picture of the P83 connector. I can see metal around the female holes on the A connector and the B connector but the third hole which I think is the C.

How do I do that. I looked at the governor but not sure were to adjust. I unscrewed the cap and there was a bolt with a nut on it but wasn't sure if that was it. I have been searching the TMs but I haven't found the governor adjustment process yet. Any help would be appreciated!

Fixed Hydraulic pump issue Well I took the hydraulic pump back apart to confirm the proper installation of by rebuild parts and looked at the level of hydraulic fluid. I added some more since all the air parts are above the plate and success!! Now on to my CTIS five flashing lights problem...

I want to say I was certain that it was set but I will check tomorrow because I have about four hours to work on the truck. I am going to pull apart the pump again just to confirm that I did everything correctly. Then I will try tracing the lines and switching the lines to see if that works...

Ok, Today I pulled the hydraulic pump, cleaned and replaced the gaskets and seals like previous posts. After a got everything hooked back up it not only didn't work the backup pump stopped working also. I cleaned the resevior too. It was nasty with a fat like substance in the bottom. Just to...