Search results

Suprman (Will)'s person is probably far far from you... since Will is in Connecticut and your in TX

searching TM's but someone here may be faster than I will find it. If so please speak up. In the hub do you load/pack anything else with grease beside bearings prior to putting in hub oil? UPDATE: the TM just says pack the bearings. Does not mention anything special about grease that I...

is this the seal that goes in the axle tube end and on the spindle on each side? UPDATE: upon reading back thru this thread that seems to be the case. They are spendy at over $50 each. Ordered 4 (two per side) though probably could leave the one at end of the axle tube..... as it was holding...

unfortunately; in your last post, half your pics don't show. First four show as nothing but a link line that states "attachment xzy" with xyz being a number

be a good thread to put torque figures for the various items reinstalled

here is some swami prayer magic to help:usafss: keep us posted....

....Thankfully my friend Mike Alley at A&B Fabrication, in Minden, created this from aluminum for the project... Using this I had the CTIS seals and the front axle outer seals installed and the front half shafts inserted.... What size seal driver is needed?

or net syntax.

wrong thread.... apologies.. Moderator please remove this post

Point well taken (pardon the pun) https://www.steelsoldiers.com/showthread.php?181102-Swapping-front-3rd-via-pulling-hub-and-stub-axle-as-a-unit

thank you for your input. You might can save me additional time.... got an idea on what section of tm covered the King Pins you shimmed?

for quick install of highspeed 3rd in front axle (mostly so can get stock one/core out and ready for pickup asap) do ya'll think you could remove 4 bolts above and below king pin? on backside ... and then slide whole thing; axle and all outward so can swap the 3rd??? or will there be...

ahhh.. so for changing rear tires w/locker we need to jack truck up little higher and use a home brewed cradle the tire sits in with rollers (skateboard wheels?) within it to allow us to spin the tire to match ctis bolt. hmmm... much thanks.... will keep in mind