Search results

http://davidsonsalesshop.com/templates/product_ProductBasic.aspx?ProductGuid=332-902&GroupGuid=41 Don't look like $120. to me.

Check/measure the length of the dipstick. Also keep the light and add the oil pressure gauge. Use a brass T at the sending unit. I will be going out for pictures of some other parts shortly and post them. Good Luck. Glad you have the lights working. Replace that dimmer switch as a safety to...

Personally I would shop vac the fluid from that master cylinder and replace the entire master cylinder, calipers and wheel cylinders. While I was at it I would change the rear axle seals and repack the front wheel bearings and spindle bearings. Do it right. It will cost less than $200. for all...

Do make sure you have the lower support bracket from the pump to the block. It will break the bracket eventually if all the brackets are not in place. Like I mentioned. Many of these parts are getting harder to find. The PS bracket was a $12. item back in the day. But like many other things on...

May I suggest getting the power steering pump belt tight in the same way. Do it first and then size your Generator 1 belt after that one is good and tight. Do NOT pry on the pump reservoir. Use the shaft or the bottom adjusting slot bracket area as a pry point. Poor design. Could have added a...

My best luck on the V belts is to drive the truck to the parts store with the old squeaky/squealing belts and walk in and out with belts that fit as tight as possible when the alternators are in a fully collapsed position. I even go as far as turn the alternator with a wrench to get the belts...

Where is BORN1619? That is my first question.