-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
J
Mep-802a engine change
It may smoke some but not a lot and it should not run rough. Are you sure the engine is a reman? Let it run about 10 mins and if its still running rough and smoking, you may have more issues.- jamawieb
- Post #20
- Forum: Generators
-
J
Mep-802a engine change
Looking good, just switch the rotor and flywheel over to the new engine and put it back in reverse.- jamawieb
- Post #15
- Forum: Generators
-
J
Mep-802a engine change
You will need to unbolt the lug panel and push it to the side. Then take the center support off (inbetween the doors on the back) so you can get a puller on the rotor bearing, take the louvered cover off, take the four nuts off holding the stator (housing) to the motor, and finally just lift the...- jamawieb
- Post #11
- Forum: Generators
-
J
Mep-802a engine change
I usually take the back half (radiator side) in one piece. Unbolt from the skid and pull that section with the radiator off. Then I leave the generator head bolted to the skid and use a 3 point puller on the back of the generator head to push the rotor out of the housing with the engine...- jamawieb
- Post #7
- Forum: Generators