Search results

The TM says to use a timing light and show the adapter you are talking about. I gues I need to find one. I got it running and it sounds, for 30-40 sec then the Hzerts start to drop off then it starts to pop miss and back fire?? It going to warm up to day so I can take it out side to test run...

I got it running. The TM said to remove the rocker cover for #1 and trun the crank until both rocker were "does" I think this is military for lose:-P and the time mark is seen and then set the mag to #1 and line up the marks. Now I just need to get a timing light to fine tune it. Will a timing...

Thanks Mangus you were right the TM is wrong both wires go to the same spot. I now have fire. Cleaned the carb and now have fuel. Now I just need to get the timing right:cry: Fire ball out carb not good thing. Hopefully I'll have backup power before long:-P And even more hope fully I wont need...

OK how? The only wire going to the magneto is the one that hooks the the end of the condeser? I'm a little slow on this so bare with me. And thanks for the help.

The strange thing about this is there were rebuilt in 81 with 3XX hours and crated on the trailer. When I uncrated them they had 5XX hours:roll::roll: The plugs in one looked brand new 0 time on them, where did the hours come from? What truns the eng off?? Yes I know the switch but what does...

Where would I see a spark??

I'm tring to get my new to me 10k gen started. But it will not start as far as I can tell its getting no spark. Tryed new plugs,checked/tested the wires. Looked inside the mag reset the points. Some one had both wire (coil and condeser) hooked to the same point on the point. That did not seem...