Search results

I know how to check the diodes but was wondering if there was a voltage parameter that I should be looking for.

Im not clear on what values i should be looking for when testing the main gen 1n1190/r diodes.

Ok, I will test those tommorow since I already removed the bell housing to get to the exitor. Thanks again.

A1 diode as in a bad avr board? Where is the main gen diode located?

I temo I removed the diode and tested it. Thats how i got the 10.5 ohms on r16

R16 resistor is showing 10.5 ohms instead of the 3k in the manual. Im going to replace it.

I agree, tested the exitor leads and got a 28.2 reading. Close enough to the 3 ohms.

All my libby parts match exept r16 which i could not find. These are the test results. I think i have en exitor problem.

I cant find R16 in my 805a control box. Can you point me in the right direction please. The manual has no mention when I search for it.

Will check each part. I learned about this mix and match the hard way. I have two 805a, one libby and the other trc. I put the TRC avr on the libby and the avr started smoking. Yikes. 🤪

Hi Guy, I have the same undervoltage problem with my 805a. The voltage drops once I release S1 even after 10 seconds. I have a libby AVR and changed the capacitor for good measure but Im only getting 60VAC on pins 7&8. The hertz show low but when tested its adjustable to 60hz and speeds up the...