• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

 

Search results

  1. M

    ABS wiring component

    Can you measure for voltage with ignition on between the A and B terminals of the connector to ground? There should be no continuity between either pin and the 12V or 24V rails. Anything 5V or less to ground is OK. A fault on the J1939 bus would likely cause the ABS light to stay on if it's...
  2. M

    ABS wiring component

    The -p006 modification comes with the weld cap like that on the DT04 housing from the factory. You can do the same thing with a 1/2W 120 Ohm resistor and contacts between A and B to get the same effect, without the environmental rating. Here's the TE product page and dimensional drawing. There...
  3. M

    ABS wiring component

    While I'm not familiar with the wiring there at all, that looks a lot like a DT04-3P-P006 (it would come assembled like that with a blue "J1939" wedge lock, capped off wire seal, and two gold contacts installed). A short to battery and ground across 120 Ohms would probably get the 1/2W resistor...
108,379members
163,685threads
2,303,028posts
1,160online users
Top
✖
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks