Search results

So looks like my transistors are bad does anyone know what I need / where I can find replacements? Sent from my SAMSUNG-SM-G930A using Tapatalk

Hey all so quick updates new VR board from lakeland did the trick thanks! @Ray for the fun of it I kind of want to try repairing the old board could you tell me what the replacement parts were on ebay? Sent from my SAMSUNG-SM-G930A using Tapatalk

Hey all so I am leaning toward it being the vr board disconnected t17 wire and voltage stayed at the same its been... Anyone know where / how to repair the VR board. Also how do I test the transformers? Thanks again! Mitch Sent from my SAMSUNG-SM-G930A using Tapatalk

Yeah tried that no luck the voltage regulator switch does nothing at all even after rotating it 50 times. Could my voltage regulator be bad and if so how do I test it? Thanks! Mitch Sent from my SAMSUNG-SM-G930A using Tapatalk

Checked that it reads about 120 on the dot. Sent from my SAMSUNG-SM-G930A using Tapatalk

Hey all thanks so much for he help! Got the new gauge in removed the transducer and have solid voltage at both the plugs and lugs.. Now new problem is why is my voltage so high!? I am getting about 160 at the 120 outlet and same on lugs for 120. When I try to adjust voltage using the voltage...

I just put s8 in the position L3 L3/L1 1 it was in a wrong position before I believe is that correct? I should be getting my throttle cable in today or tomorrow as well as the aftermarket gauge which says no transducer needed so will give it another go when I get that in and see what happens...

Do I need to remove the transducer? I found a part in the box that says transducer but it's labeled a3. Sent from my SAMSUNG-SM-G890A using Tapatalk

Where's the transducer go? Right now it looks like just the meter. Sent from my SAMSUNG-SM-G890A using Tapatalk

Less then full speed. I tried full mid and low and low throttle seems to be where the volt gauge reads 120. Either way still not getting anything at the lugs. I have transfer switch set to 120 1 phase. Sent from my SAMSUNG-SM-G890A using Tapatalk

Ok so just went out and gave it a shot it looks like I got voltage once at the lugs but then I couldn't get it to read anything again. Another thing I noticed is as I throttle the engine it looks like the gauge is loosing voltage goers down from 120 to 100 but if I let off the throttle goes back...

Haven't checked the lugs yet I would figure the outlets should have power above everything else since they bypass a lot. I have checked some of the TM's not really sure where to start though especially since the voltage gauge is saying it has power. Sent from my SAMSUNG-SM-G890A using Tapatalk

Hey All, Recently just picked up an mep002 was kind of in rough shape but i have it running now. Voltage gauge is showing 120 but problem is when i try and plug something into the plugs i am not getting any power? Any ideas where i should start? Do you need to have the HZ gauge hooked up for it...