Search results

Thank you Chain, I will focus my effort on the starter lockout switch and start with the adjustment procedure. Michael

After cool down of about a hour the unit restarted normally and I measured 24 volts from the solenoid to the starter and felt the solenoild kick in. So somehow the starter solenoid is not being activated after running for 30 minutes or so and will not work again until the unit cools down. Still...

OK, with you guys (Dock and Chain) input I am looking at the starter. I can't get a jumper wire onto the positive starter solenoid terminal or positive starter terminal, too tight in there. So while in the no start mode (not cooled down enough yet) I measured the DC voltage on what appears to be...

Hi again, I found a small bit of mouse nest in the box that contains the fuel shut off solinoid and cleaned it out and also blew out the engine fins from both sides with compressed air. I again started it and ran it for about 30 minutes with no issues, then when I imediately tried to restart it...

thank you Chainbreaker. I do hold the start switch fully on, but the engine does not turn over at all, just that loud clunk. I will proceed to check the safety circuits and check for cooling air restrictions abd oil pressure.

hi all, The last two times I started the MEP002 to check and charge the batteries it will not restart until I wait an hour or two. Then it starts and runs fine again. Upon trying to restart immediately after shutdown I hear a loud clunk noise near the front right side of the set (looking from...