Search results

I can see in the picture the stud sticking out that has nothing connected to it, I believe the empty stud on your alt is where you want to connect the Dakota digital. On the drivers side there will be a single wire with push on plug that goes on that stud if the alt were on the drivers side. I...

The ste/ice connection goes to the drivers side alt. If the truck has been converted to 12 volt and the drivers alt removed then the wiring will not be connected anymore and thus you will need to go directly to the passenger side alt.

http://www.steelsoldiers.com/showthread.php?100007-gauge-cluster-conversion-question here is the thread that contains most of my dash changes. check the diagrams closely, I think there was a mistake on mine that did not get corrected. check the ones in this thread with wiring diagrams in...

steering column gauge mount in order to use the lmc tach, you need the gauge cluster that has the associated printed circuit board. I used the lmc tach, works great, looks factory but my gauge cluster is highly modified and everything but the lights is wired individually. the printed circuit...

found some pics, you can see where I moved the light to. all of the idiot light sensors were combined to light the service engine light. So I have dual sensors on the motor. IF I am not paying attention to a gauge either the water temp, oil pressure will light the idiot light. I had to put...

http://www.lmctruck.com/icatalog/csb/t.aspx I had to rewire my cluster and did not use printed board (except for lighting) but I did a lot of other things than just adding a tach. Went to all gauges and moved the idiot lights, I did not remove them except 4x4 light. One thing you have to do...

LMC has what you need, get low rpm tach. have to not use factory connections in bezel. make new wires to connect to not using the plug that goes into the bezel. LMC has the fuel gauge and tach. get the correct circuit board and I think you can rewire the plug to the correct terminals and use...

http://www.dakotadigital.com/index.cfm/page/ptype=product/product_id=128/category_id=694/mode=prod/prd128.htm I have the DS-1. The new model is DS-1e. Mine dose not have the digital read out. connect to alt brown wire. you can use other sensors also