Search results

wow its not that complicated or maybe im just really above average and that's not it turn it around drill one hole reuse all the same ubolts nuts washers and dirt put back togeather tighten it up and start rolling smoke sorry but its just a simple mod low brain power lots of back knees and pb...

I would be glad to take some pics but its a simple mod just take the perch off rotate it so the front is the back and the back is the front relocate line up hole so it will sit flat on top of the axel housing then bolt it all back togeather and your truck will drive normal again i dont know alll...

i wish i had taken some but it was a pain in the rear to get everything apart it I DOUBT IF MINE HAD EVER BEEN APART SINCE IT WAS BUILT and the hole not lining up kinda through me off i didn't know that until i got into it and what i thought was going to take me a couple of hours took almost...

yes took them out turned them 180 degrees when you do that the axel line up hole wont sit down over pin because it is not in the center of the perch it is off set so I marked it best I could I did use an over sized bit because the shim sits at an angle so your hole does too bolt it back up and...

I just recently bob my deuce went with the G177 s it wandered from one side of the road to the other and steering wheel didnt return to center turned my front spacers around like it shows and deuce drives like it did before the G177 s so dont even think twice about it just get r done oyea it is...