Search results

Well i had a friend that repaired the T1 transformer for me and installed today and they was my whole problem. Thanks to everybody that replied to me on here. I have a new T1 ordered just to have as backup also.

FYI i also believe on figure 6-4 where you sent me has transformer T1 and T2 labeled backwards . Hummmm

Thanks for the info, i read that and checked the ohms. High side basically open and low side was correct. According to schematic i could tell high side is 120vac and if i did my calculations right according to the ohms the low side was 6vac on each tap . I was trying to figure out low side...

Does anybody happen to know what the specs is on this transformer T1? Line/ low side voltages? appears to me high side is 160v without voltage regulator working and 120 with voltage regulator working. low side 6 volts on each side with a center tap for a total 12v this is My best guess.

Looks like T1 the larger of the two is open across H1 and H2 so now looking for one of those. NSN 5950-01-055-1266 72-5005 P8093

I have tested R1 with ohm meter and get 0 to 954 ohms from low to high on adjustment no jumping around as I adjust it was smooth. Volt reg board I bought a certified one to replace the one I had for which now I think is good also. I had a electronics buddy test items on board of old one and he...

I was wandering if the only difference was the outside marking. CVT/CT. I work with current sensors and lots of different part numbers do the same thing. There is two sets of wires running threw the two of these sensors and one is for sensing current and the other voltage so in reality they...

I have worked on this for a while now. I believe my voltage regulator board and Rheostat is good but they however will not adjust the voltage at all. I am leaning towards CVT as the problem. I plan to test first chance but my main Question is if I have a extra CT can I install in place of CVT...