Search results

Simple enough for me! Thanks a bunch, I'll have one done by lunch tomorrow, may even have some matching chain too.

Found some 1 1/4 x 1/4 and some 3/4 bar stock. I tried it on the repaired leg and it actually worked quite slick - I made the female slotted end a pretty snug fit so no wobble when operating.... though the stowage design does not inspire much confidence for longevity. Since it's only a repro...

Thanks for the info - Actually, for me, I was way off!! And if I had gone my route, there would have been skinned knuckles for sure! I will time the build to see what $$ it would cost to reproduce. The "R-pin" idea is pretty sad, so I am sure that there will be travelling losses in the future!

So - from your pics and the size of both; the handle stowage retainer (with "R" pin) [1/4 thick & 1" from pin center to leg - using your pic I didn't use below] and my hand (let's assume that is a reasonable guess, these are the dims that seem to scale. Let me know if this is close enough...

So, next fab info/dims/pics needed is retaining pin for rear steady leg...

I didnt consider that it could have been a simple detatchable deal - I was conjuring some hinged device!! Cheers.

Yeah - I'm trying to figure out what the original handle looked like considering what room you have to operate it, where it would be when stowed and how it fits into the "R" pin keeper on the lower portion.... Pictures please existing owners!!!

But I do need a winding handle or a good pic of one, as 'mine' was missing.

Recent acquisition of former generator trailer - found mangled jack leg in the ground rod storage locker. Nearly all of the individual components were bent, broke, distorted or combinations there of. Bevel gear shaft was bent and distorted bushing housing on one side. Bigger hole was...