24V MILITARY VEHICLE FLASHER w/10 pins

[CES 3245th]

I could use a little help on this, what am I missing here? I bought a new vehicle flasher LED compatible. Of Course I didn't pull off the old one before I ordered the new one and of course I assumed it was the same,wrong! The new one has (3) pins and the old one has (10) pins. I have attached some pictures of the new one as well as the old. So any help on this would be greatly appreciated. 1983 M923A1 5 Ton

 

[Swamp Donkey]

You removed the Failsafe Warning Module instead of the Flasher Module. The Flasher Module only uses 3 pins like the new one you have. The FWM is on the left side by the vent and the Flasher Module is on the firewall next to the steering column.

 

[CES 3245th]

You are absolutely correct, which would explain why it doesn't fit! I should look before I leap next time! The one in the attached picture is the configuration I have above the steering column. Should check it!

Thanks


NO LOAD FLASHER, TURN SIGNAL LED

 

[Swamp Donkey]

You are absolutely correct, which would explain why it doesn't fit! I should look before I leap next time! The one in the attached picture is the configuration I have above the steering column. Should check it!
Thanks


View attachment 729806 NO LOAD FLASHER, TURN SIGNAL LED

Both style flashers you've listed work with LED lights. I've had both styles in my truck. While you have the FWM and Flasher Module off, save yourself some headache later and take care of the grounding areas for both.

 

[CES 3245th]

Good advice, I definitely will make sure that there is a good ground for both. Thanks Swamp Donkey