Connected my MEP-803A the proper way as my home standby generator... Install pics...

[nextalcupfan]

Here is mine disconnected. (Vertical bar to the right of the neutral lug)

Seeing Ray70's panel makes me want to clean mine....

 

[Racinc2000]

Got it! Thanks fellers!

 

[Light in the Dark]

A better shot from another thread

Question regarding wiring on the panel side

I'm running 6/4 type w cord running from the 803a to a 50a generator inlet. My question is regarding the ground wire. I know the neutral (white) wire connects to the neutral bar. Do I attach the ground (green) wire to the neutral bar also or should I connect to the point where the box is...

www.steelsoldiers.com

 

[RugerAC]

Hopefully I will get a reply on this question. I have the MEP-803A and I am trying to find a threaded female coupler for the exhaust so I can run it out of my pole barn. Have not had any luck so far in identifying it . Thanks

 

[Ray70]

Your exhaust pipe is a standard NPT thread, 1 1/4" if I recall. I don't know what you want to use for pipe but a threaded pipe coupling or union will work.
An EMT tube coupling will work too. You just need to decide what and how you want to attach pipe to the coupling ( weld, exhaust clamp etc. depending on what you plan to use )

 

[Light in the Dark]

Yup just 1.25" NPT black iron coupler should thread up fine. Make sure to put a flexible joint somewhere in the exhaust, to isolate NVH from the machine to the exhaust system.