- 270
- 103
- 43
- Location
- Mico, Texas
Had to use my impact wrench to get most of them off. Replaced with OEM nuts.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
HMMWV Lug Nuts
- Thread starter 4x4nutz
- Start date
Mario
Active member
- 317
- 88
- 28
- Location
- Rio Rancho, NM
I ordered a set from fleaBay. 32 bucks with shipping, so about a buck a piece
Sent from my SM-G955U using Tapatalk
Sent from my SM-G955U using Tapatalk
cwajciec
Member
- 68
- 5
- 8
- Location
- Richmond VA
Resurrecting an old thread. I had some lug nuts that were very tight all the way off. Too tight as in 600 ft”lbs impact tight. I ran a 9/16 NF Tap through them and now they spin on largely by hand and torque down as they should. The tap didn’t cut any metal from the threads but did straighten some of the threads. That leads me to believe they were overtorqued and rolled over the thread pitch a bit.