ltcray
Member
- 40
- 0
- 6
- Location
- Simpsonville/ South Carolina
Sold my M1008 to a gentleman in NC, and was already in the market for its replacement. Guy not too far from me had a nicely repainted 1009. He used Rapco 383, and did a pretty good job.
Now for the other stuff: I need to repair/replace the rear deck. Looks like the depo left the back window open. The floor's got some holes right next to the tailgate. Be a good time to do the fuel sending unit as well, since its not working. And, I'll need a tailgate crank with lock core.
I also noticed some mentally challenged monkey drilled a hole centered in the cab roof. So I'm also looking for a light rack or bar to mount. (old MP type?) That way I can mount a ham radio antenna and route the coax thru the hole using a sealed fitting. Just camouflage....
Send me a message if anybody has ideas on this or these parts for sale.
Update... fuel sending unit is working now. Found the broken wire behind the cross member in front of the fuel tank. Exhaust to be replaced next... Tail pipes broken off the mufflers, and some idiot tried JB Weld to patch holes in the mufflers.... amateurs...
Now for the other stuff: I need to repair/replace the rear deck. Looks like the depo left the back window open. The floor's got some holes right next to the tailgate. Be a good time to do the fuel sending unit as well, since its not working. And, I'll need a tailgate crank with lock core.
I also noticed some mentally challenged monkey drilled a hole centered in the cab roof. So I'm also looking for a light rack or bar to mount. (old MP type?) That way I can mount a ham radio antenna and route the coax thru the hole using a sealed fitting. Just camouflage....
Send me a message if anybody has ideas on this or these parts for sale.
Update... fuel sending unit is working now. Found the broken wire behind the cross member in front of the fuel tank. Exhaust to be replaced next... Tail pipes broken off the mufflers, and some idiot tried JB Weld to patch holes in the mufflers.... amateurs...
Last edited: